

Automated driveway gates for Toongabbie, planned around the narrow older driveways and the fall toward the creek that catch most gate suppliers out.
Toongabbie is an established suburb with established constraints. Many of the homes date from the fifties through the seventies, driveways were sized for the cars of the time rather than a modern dual cab, and streets close to Toongabbie Creek carry a noticeable fall. Under Parramatta Council the suburb also has a steady stream of renovations and secondary dwellings, which changes how a driveway is used long after it was poured.
The narrow driveway problem is the one we solve most often here. Where the opening is barely wider than the vehicle, gate posts eat into the clear width, so we set the posts outside the driveway line wherever the boundary allows and choose hardware with a slim profile. Where a slider has no run-back, a bi-fold arrangement recovers most of the opening without swinging out over the footpath.
On the creek side of Toongabbie we also check for drainage across the gate line, because water running along a fence into a track is what kills sliding gates in this suburb. Call 0492 879 796 to book a free on-site measure.
Posts set outside the driveway line and slim hardware chosen so a tight Toongabbie opening keeps as much clear width as possible.
Folding leaves for frontages with no run-back for a slider and no room to swing a full-length leaf into the yard.
Ground tracks laid with fall and drainage in mind, because water running down toward Toongabbie Creek will find any low point.
Twin leaves hung to open into the property on adjustable hinges, easy to service and quiet in a close-set street.
Keypads and extra remotes where a granny flat or renovation has added a second household to one Toongabbie driveway.
Re-hanging, re-tracking and re-automating older gates around Toongabbie and Old Toongabbie that have dropped or seized.
It can if the posts are placed carelessly, which is exactly what we plan around. Where the boundary allows we set the gate posts outside the driveway edge so the clear opening is not reduced, and we select hinge and roller hardware with a slim profile. On very tight openings a bi-fold gate is often better than a slider because it needs less clear boundary to park the leaves.
It affects the track and the drainage more than the gate itself. Streets sloping toward Toongabbie Creek shed water along fence lines, and a ground track sitting in the path of that water fills with silt and grit until the gate binds. We lay tracks with drainage in mind, or move you to a cantilever gate that has no track for water to run into.
Frequently. Plenty of Toongabbie and Old Toongabbie homes have a steel gate that is structurally fine but has dropped on tired hinges, lost its rollers or had a motor die. Re-hanging, re-tracking, replacing the motor and adding the safety beams that older installs never had is usually far less work than a new gate, and we will tell you honestly when the frame is past saving.
A keypad at the gate with separate user codes, plus additional remotes coded to the same receiver, means the second household does not depend on the main house to get in. A free exit sensor in the driveway lets anyone leave without a remote at all, which avoids the classic problem of the gate being propped open for convenience.
We install driveway gates in Old Toongabbie, Seven Hills, Winston Hills, Pendle Hill, Girraween and Wentworthville as well as Toongabbie. Our Wentworthville workshop is only a few minutes away, which keeps measures, installation and any later service call simple to arrange.
Contact Sydney's trusted fencing contractors and landscape designers
77 Garfield St
Wentworthville NSW 2145
75 644 310 547

Professional since 2016
No-obligation assessments across Sydney
Established local business
Full compliance and protection
Premium suppliers and warranties
Reliable project delivery
Best value for money
Contact us today for your free consultation and quote
Transform your Sydney property with expert fencing contractors and landscape designers