

Timber Fencing across Sydney, built to handle the conditions rather than to suit a catalogue.
We have been doing timber fencing across Sydney long enough to know which streets throw up surprises. The one that catches people out most often is a very wide range of housing eras with different original boundary types.
Timber Fencing in Sydney is as much about access and set-out as it is about materials. On everything from flat river plain to steep sandstone escarpment, getting the sequence right is what keeps a job to program.
Ask three contractors for timber fencing in Sydney and you may get three different answers. The difference usually comes down to whether anyone has looked at councils that each interpret the same state controls slightly differently before pricing the job.
Call 0492 879 796 for a free measure in Sydney and we will walk the job with you before anything is priced.
Tree cover and root zones matter around Sydney. Roots are worked around rather than cut through, both because the tree matters and because a cut root under a footing is a future problem.
The two variables we record first on any Sydney site are the fall along the run and what the ground does at footing depth. On reactive shale clay in the west, sandstone and sand through the coast and north, those two answers set the specification for everything above them.
Local housing stock is largely the full spread of Sydney housing, from Victorian terrace to new release estate, and that tells you a lot about what is already in the ground: original service runs, old footings and the occasional buried slab nobody remembered.
Battens run horizontally for a contemporary look on a courtyard or pool surround.
Replacing a failed section rather than a whole run where the rest is sound.
Hardwood rails and posts where a longer service life justifies the harder timber.
Palings butted tight with the rails exposed on one side, the most economical timber format.
H4 treated pine posts and rails for in-ground durability at a sensible outlay.
Timber gates braced properly so they do not drop out of square in the first summer.
Colour and finish choice around Sydney tends to follow the streetscape more than personal taste, particularly on blocks where you are working with coastal salt exposure on one side of the city and cracking clay on the other.
Everything we install carries a manufacturer specification, and we install to it. Warranty claims fail on installation detail far more often than on product defect.
Heritage conservation, bushfire prone land and flood planning levels all sit on top of the standard controls in parts of the greater Sydney basin. Any of the three can change what is permitted on a boundary.
Before anything is fabricated for a Sydney property, we check what applies. the relevant local council publishes its controls, and heritage, bushfire and flood mapping can each change the answer entirely.
Everything is measured on site and photographed, and the quote is written from that rather than from a phone conversation. That is why what arrives on the day is what was priced.
Services are located before excavation, every time. Around Sydney the older streets carry runs that are not where the plans say they are, and a strike is expensive for everyone.
Most timber fencing enquiries we take in Sydney come from the same place: palings that have cupped and pulled their fixings. It is worth understanding why that happens here before deciding what to replace it with.
A little, yes. Timber gives up moisture after installation and palings shrink across the width. A lapped-and-capped fence handles that because the overlap absorbs the movement. A butted fence will show light between the boards, which is worth knowing before you choose the format.
A standard dividing fence on a side or rear boundary usually does not need approval, but front boundaries are different because the relevant local council controls height and openness forward of the building line. Heritage and conservation controls can also apply. Confirm with the council before you order anything for a street frontage.
Sometimes, but it is rarely the right call. If the posts are sound and only the palings have failed, a re-clad is genuinely economical. If the posts have gone at ground level, anything built on them inherits the problem. We pull one or two posts to test before recommending either way.
Termite pressure is real across the greater Sydney basin and timber in ground contact is the obvious entry point. Treated posts, a concrete plinth and keeping garden beds and mulch away from the base all reduce the risk. We flag any active activity we find when the old fence comes out.
Hardwood is denser, holds a straight line longer and takes knocks better, which suits exposed and high-traffic boundaries. Treated pine is lighter, easier to work and more forgiving on a long run. On everything from flat river plain to steep sandstone escarpment, the practical answer is usually hardwood rails with treated posts, because the rails do the structural work.
Contact Sydney's trusted fencing contractors and landscape designers
77 Garfield St
Wentworthville NSW 2145
75 644 310 547

Professional since 2016
No-obligation assessments across Sydney
Established local business
Full compliance and protection
Premium suppliers and warranties
Reliable project delivery
Best value for money
Contact us today for your free consultation and quote
Transform your Sydney property with expert fencing contractors and landscape designers