

Glass and aluminium pool barriers for Gregory Hills, engineered for stepped and retained backyards on the ridge blocks.
Gregory Hills climbs a ridge on the eastern edge of the Camden Council area, which gives many homes here a genuine outlook but also leaves them with backyards that fall away sharply behind the house. Split-level slabs, block retaining walls and stepped terraces are the norm rather than the exception, and that terrain changes how a pool barrier has to be designed.
On a sloping Gregory Hills yard the barrier cannot simply run level. Panels are stepped so that the 1200mm minimum height is held at every point measured from the finished ground on the outside, while the gap beneath each panel stays under 100mm on the high side. Retaining walls make the 900mm non-climbable zone the bigger issue, because a wall top or garden step within that arc gives a child a foothold and will fail an AS 1926.1 inspection.
We survey the levels across the pool surround before quoting so the stepping pattern, spigot heights and gate threshold are all resolved on paper first. You then receive a fixed written quote from that free measure. To arrange a Gregory Hills site visit call 0492 879 796 and we will come to you.
Slim posts carrying glass infill, the practical pick for stepped Gregory Hills yards where a level change happens mid run.
Toughened panels on spigots for the flatter Gregory Hills terraces immediately behind the alfresco, keeping the outlook intact.
Panel runs stepped in even increments down a Gregory Hills fall, holding full barrier height across the whole slope.
Barriers set out to keep wall tops, planters and terrace steps clear of the 900mm non-climbable zone.
Self-closing gates hung true on stepped ground so they latch every time rather than dragging on the high side.
A proper survey of the pool surround before ordering, so panel heights and spigot positions suit the actual fall of your block.
We step the barrier. Rather than following the ground, the panels are set in level runs that drop in increments down the fall, so the 1200mm minimum height is achieved everywhere while the gap under each panel stays within 100mm. On steeper Gregory Hills yards we sometimes trench or pour a small kerb under a panel to close the low side.
It can. In Gregory Hills the most common failure is a block retaining wall or garden terrace sitting inside the 900mm non-climbable zone measured from the top of the barrier. Depending on the geometry we either move the fence line, raise the barrier, or work with you to remove the foothold before certification.
Sloping sites take more setout, more panel variation and sometimes extra concrete work, so a flat rate would be misleading. We measure and survey your Gregory Hills pool surround free of charge and issue a fixed written quote that covers the stepping and any groundwork needed.
If the pool sits on the view side of the house, glass protects that outlook and is worth the extra. If the barrier runs along a retained boundary where there is nothing to see, aluminium does the same safety job for less and copes better with soil movement behind a wall.
We cover Gregory Hills, Oran Park, Gledswood Hills, Harrington Park, Catherine Field, Narellan and Narellan Vale. Our installers work through the Camden and Campbelltown corridors weekly and know the estates and their design guidelines.
Contact Sydney's trusted fencing contractors and landscape designers
77 Garfield St
Wentworthville NSW 2145
75 644 310 547

Professional since 2016
No-obligation assessments across Sydney
Established local business
Full compliance and protection
Premium suppliers and warranties
Reliable project delivery
Best value for money
Contact us today for your free consultation and quote
Transform your Sydney property with expert fencing contractors and landscape designers