Anti Climb Fencing Penrith

358 anti climb mesh and rail toppings installed across Penrith, built to AS 1725 in heights from 2.1m through to 3.6m.

Call Now Free Quote

Licensed & Insured$20M Public Liability358 Mesh SpecialistsPenrith Site Compounds

Fully Licensed

NSW contractor licence

AS 1725 Built

Standards compliant

Fast Install

Clear timelines

5-Star Rated

Google reviews

Anti Climb Fencing in Penrith

Penrith carries an unusual mix of assets that need climb proof boundaries. There are trade and plant yards through the Dunheved and Kingswood industrial pockets, Endeavour Energy substations feeding the growth corridor, pump stations along the Nepean, large school and tertiary campuses at Kingswood and Werrington, and event infrastructure around the stadium precinct. Every one of them attracts after hours climbers, and none of them suits razor wire.

Anti climb fencing solves that with geometry rather than barbs. A 358 panel has 76.2mm x 12.7mm apertures formed from 4mm wire, so the opening is narrower than a boot toe and far too tight to slide in a bolt cutter jaw or a crowbar. Penrith runs go out at 2.1m, 2.4m, 3.0m and 3.6m to AS 1725, bolted to RHS posts with one way tamper proof fixings, galvanised or powder coated black.

If you need a Penrith perimeter secured, we measure the site free and set the whole scope out in one fixed written quote. Call 0492 879 796 to get on the install schedule.

What We Install in Penrith

358 mesh panels in 2.1m, 2.4m, 3.0m and 3.6m
Construction site compounds and plant yards
Substation and utility asset enclosures
School, TAFE and campus perimeters
Anti climb rail toppings for existing fences
Galvanised or powder coated panel finishes
One way tamper proof panel fixings
358 sliding and swing security gates

Anti Climb Fencing Options in Penrith

Site Compound Mesh

Climb proof compounds for Penrith builders holding plant, formwork and copper on open lots across the release areas.

Utility Enclosures

Substation and pump station cages built to asset owner specification with clear sight lines for camera coverage.

Campus Perimeters

Long runs for Kingswood and Werrington campuses where students need visibility through the fence but not a way over it.

Rail and Spike Tops

Anti climb rail or spike topping added to existing Penrith palisade and chain wire without replacing the whole fence.

Powder Coat Finishes

Black, monument and green powder coat over galvanising for street facing Penrith boundaries that have to look tidy.

Heavy Duty Gates

Cantilever sliders and double swing gates clad in matching 358 mesh, sized for truck and plant movements.

Anti Climb Fencing Service Area Around Penrith

St MarysKingswoodWerringtonCambridge ParkEmu PlainsLeonay

Anti Climb Fencing Penrith FAQs

What makes 358 mesh climb proof on a Penrith site?

The aperture does the work. 358 mesh has 76.2mm x 12.7mm openings in 4mm wire, so no gap is wide enough for a finger, a toe cap or the jaws of a bolt cutter. A climber has nothing to hold and no leverage point, which is why the same panel used in correctional work now protects Penrith substations and site compounds.

What height anti climb fence should I use in Penrith?

Schools and childcare usually sit at 2.1m to 2.4m. Trade yards, storage and industrial boundaries around Dunheved and Kingswood are commonly 2.4m to 3.0m. Substations, water assets and high value plant compounds go to 3.0m or 3.6m. AS 1725 covers all of those heights and we build to it as standard.

Do you install anti climb fencing on active Penrith construction sites?

Yes. Release area builders around Jordan Springs, Caddens and Glenmore Park use 358 panels for the long term compound line and then reuse them on the next stage. Panels bolt to driven or concreted posts and come off cleanly with the correct security key.

Can you add anti climb protection without replacing my existing fence?

Often we can. Where the posts and footings are sound, a rotating anti climb rail, an angled extension arm or a spike topping fitted to the top of existing chain wire or palisade lifts the effective height and removes the grip point at the top rail.

How long does an anti climb mesh install take in Penrith?

A typical 2.4m commercial run of sixty to eighty metres takes two to three days once footings have cured, gates included. Larger utility compounds and campus perimeters are programmed in stages so the site stays secure overnight throughout the works.